HWPS-Actions.md

@@ -554,15 +554,17 @@ Assembly action allowing a profile to abut the face of an accessory at the node;
 
 - Use case : Assembly procedure
 - Parameters : 
-   - Index of bar 1: index of the bar in the node of the profile(s) to abut the face of an accessory
-   - Line 1 of profile 1: line to identify the profile(s) of bar 1 to undergo the abutting action
-   - Parameterization value: possibility to identify the profiles to be subjected to the action (in addition to the identification line) by specifying the parameterization value of their positioned profile action
-   - Parameterization value: allows you to specify whether or not to use the parameterization value of the profile(s) of bar 1
-  - Surface : Face on which the profile(s) of bar IB1 should abut.
-     -Note: Accessory identification: 
-This face is also used to identify the accessory which is at the node.  If several accessories have the same face, it is necessary to use the parameter value of the accessory placement action at the node to identify the accessory on which you wish to make the stop.
-See also : creating a surface : Add a surface in the 'Points-Lines-Surfaces' tool
-See also: defining a surface on a 3D object
+   - **Index of bar 1** : index of the bar in the node of the profile(s) to abut the face of an accessory
+   - **Line 1 of profile 1** : line to identify the profile(s) of bar 1 to undergo the abutting action
+   - **Parameterization value** : possibility to identify the profiles to be subjected to the action (in addition to the identification line) by specifying the parameterization value of their positioned profile action
+   - **Parameterization value** : allows you to specify whether or not to use the parameterization value of the profile(s) of bar 1
+   - **Surface** : Face on which the profile(s) of bar IB1 should abut.
+      -Note: Accessory identification: 
+      This face is also used to identify the accessory which is at the node.  If several 
+      accessories have the same face, it is necessary to use the parameter value of the accessory 
+      placement action at the node to identify the accessory on which you wish to make the stop.
+      See also : creating a surface : Add a surface in the 'Points-Lines-Surfaces' tool
+      See also: defining a surface on a 3D object