HWPS-Actions.md

@@ -561,8 +561,9 @@ Assembly action allowing a profile to abut the face of an accessory at the node;
    - **Surface** : Face on which the profile(s) of bar IB1 should abut.
        - Note: Accessory identification This face is also used to identify the accessory which is at the node. If several accessories have the same face, it is necessary to use the parameter value of the accessory placement action at the node to identify the accessory on which you wish to make the stop.
       
-      See also : creating a surface : Add a surface in the 'Points-Lines-Surfaces' tool
-      See also: defining a surface on a 3D object
+      See also : creating a surface : Add a surface in the 'Points-Lines-Surfaces' tool.
+      
+      See also: defining a surface on a 3D object.
 
  
 
@@ -1370,4 +1371,4 @@ Other possible manipulation: %7.0f: 7 digits before the decimal point and 0 afte
     - UntilPoint/10 = 10%
     - -1 = 100%
     - -5 = 500%
-    - -0.1 = 10%
+    - -0.1 = 10
\ No newline at end of file