HWPS-Actions.md

@@ -715,7 +715,7 @@ Definition of the target by the parameters of bars 2 and 3 :
 ![image](uploads/813c05a17f609a8bde4f19628503e58c/image.png)
 Definition of the line of sight by the parameters of bar 1, result:
 ![image](uploads/bdbf0d20b21e656354bbf66916919b33/image.png)
- - Note: The offset does not apply to the bar itself.  The wire volume is not modified, only the whole of the profiles of the bar is misaligned.
+   - Note: The offset does not apply to the bar itself.  The wire volume is not modified, only the whole of the profiles of the bar is misaligned.
  
 
 --------------------------------------------------------------
@@ -746,7 +746,6 @@ Definition of the line of sight by the parameters of bar 1, result:
 ![image](uploads/a2d7bc45f6e0b582fb83ca70ba30d5a7/image.png)
 
 The first 5 parameters define the profile(s) receiving the cuts:
-
     - **Bar index** : bar index of the profile(s) receiving the cuts
     - **Profile identification by line** : Line allowing to identify the profile(s) of the bar to undergo the stop action
     - **Profile mesh** : Mesh index of the considered profile
@@ -770,7 +769,6 @@ The "profile 1" assembly is calculated from projections of the section onto the
 In this example, the cutting of the cross-section to be made - starting from the origin of the section towards the positive Ys - requires to assemble it against the cutting planes defined in the order by the lines: L1, L2, L3, L4 and L5 :
 
 ![image](uploads/66cbdf061c40f9c0459e25f8f564d0df/image.png)
-   
     Note: Unlike most assembly actions, for the multi-cut action the lengths of the lines (segments) are important in order to achieve the desired result.
 --------------------------------------------------------------