HWPS-Actions.md

@@ -449,40 +449,31 @@ Assembly action allowing a profile to abut on the face of another; the face bein
      - Distance: possibility to add an additional distance to the cutting plane from the stop.  This is a distance normal to the profile section (distance in the profile extrusion frame).
  
 Example : when type of plane following the line and a negative Distance D :
- 
-         ![image](uploads/ebc19bc55754dcc38c31265a9ab7611a/image.png)
-
-
-    
-     - Parameter value: This parameter specifies whether the parameter value specified above is 
-     used to identify the profile(s) of bar 1 
-
-        - Values: 
 
-        Do not use the parameter value
+![image](uploads/ebc19bc55754dcc38c31265a9ab7611a/image.png)
 
-        Uses parameter value
 
-    - Parameter value: This parameter specifies whether the parameter value specified above is 
-  used for the identification of the profile of bar 2
-
-        - Values : 
-
-        Do not use the parameter value
+     - Parameter value: This parameter specifies whether the parameter value specified above is 
+ used to identify the profile(s) of bar 1 
+          - Values: 
+           Do not use the parameter value
+           Uses parameter value
 
-        Uses the parameter value
+     - Parameter value: This parameter specifies whether the parameter value specified above is 
+ used for the identification of the profile of bar 2
+         - Values : 
+         Do not use the parameter value
+         Uses the parameter value
 
     - Mesh index: Index of the mesh in the node 
-
       - Values: 
+           * from 0 to n.meshcount-1 : when one of the profiles concerned by the action is 
+           extruded on a mesh (in other words, in the positioned profile action, the "extrusion" 
+           parameter is mesh1 or mesh2) it is necessary to indicate on which mesh in the node 
+           the profile is located.
 
-         * from 0 to n.meshcount-1 : when one of the profiles concerned by the action is 
-         extruded on a mesh (in other words, in the positioned profile action, the "extrusion" 
-         parameter is mesh1 or mesh2) it is necessary to indicate on which mesh in the node 
-         the profile is located.
-
-         * -1 : when the profiles concerned by the action are all extruded at the bar (no 
-       notion of mesh).
+           * -1 : when the profiles concerned by the action are all extruded at the bar (no 
+           notion of mesh).
  
  Note: Stop action:
  Choice of profiles for the action according to the mesh index :