... | ... | @@ -143,21 +143,21 @@ When creating a new object of type Action, one must first choose the type of act |
|
|
- Profile : selection of the profile material to be extruded
|
|
|
- by selection in the list of articles via the "folder" icon 
|
|
|
- directly by indicating the identification of the article via the expression editor. 
|
|
|
- Extrusion : extrusion type selection
|
|
|
- **Extrusion** : extrusion type selection
|
|
|
- On the beam : the profile will be extruded over the entire length of the bar
|
|
|
- Mesh side one : the profile will be extruded the length of the mesh side one
|
|
|
- Mesh side two : the profile will be extruded the length of the mesh side two
|
|
|
- Mesh side three : the profile will be extruded the length of the mesh side three
|
|
|
- Mesh side four : the profile will be extruded the length of the mesh side four
|
|
|
- Profile position : selection of the position action that will specify how the profile is to be positioned on the bar or on another profile.
|
|
|
- Coulour:
|
|
|
- **Profile position** : selection of the position action that will specify how the profile is to be positioned on the bar or on another profile.
|
|
|
- **Coulour**:
|
|
|
- Default : the profile will take the colorization rules defined in the section
|
|
|
- Mill : the profile will not take any colouring
|
|
|
- Revert Out-In : the colours defined in the section will be reversed between inside and outside.
|
|
|
- Interior : the profile will only take the inside color
|
|
|
- Outside : the profile will only take the outside color
|
|
|
- Parametric value: value associated with the profile extruded by this action. This value can be tested later in the parameter setting to differentiate between identical profiles that should have a different behavior.
|
|
|
- Layer: from 0 to n if the profile has to be extruded according to a filler layer
|
|
|
- **Parametric value**: value associated with the profile extruded by this action. This value can be tested later in the parameter setting to differentiate between identical profiles that should have a different behavior.
|
|
|
- **Layer**: from 0 to n if the profile has to be extruded according to a filler layer
|
|
|
- for simple filling the layer = 0
|
|
|
- for multi-filling the value starts from 1 up to n
|
|
|
|
... | ... | |